Additional Tasks List
The Trailers have a rear bumper that needs to be deployed on set up, folded down for transport…..
MR75
MR73
This trailer has a dockable bed that needs to be bracketed for transport. Prepare for transport: Remove the covers from the bracket locators on…..
This lift has a wireless switch on the handrails and the lift will not work unless the button is pressed. To pack away or…..
RM15
There are 2 brackets for the bed, these are permanently secured to the floor and fold out for use and fold away when not…..
RM15
Control box, top right button to be pressed to operate front legs…..
RM15
This scanner should be sloped back to travel, if the scanner is in the upright position please contact transport before moving……
CT1108
This bed requires a lock pin to be inserted, although this is the job of the technicians you must physically try to move the…..
CT1108
Although the MRI is chirping sometimes there may be a requirement to reset the chiller when it changes between the transport and main chiller……
MIP 05
The air con units are located in the rear belly lockers, both lockers MUST be left open on setup……
MIP 05
The unit is fitted with a sink with a live feed. Connection located under N/S slide-out along with waste connection (pictured). Hoses in N/S…..
MC11CT
Generator control panel located behind grill on front o/s. Open grill and door to reveal control panel…..
MC11CT
Generator fuel fill point located behind grill on front N/S. Open grill and access door to reach fuel cap…..
MC11CT
Ensure scanner bed is in lowered position and transport brackets are fitted in front and behind scanner…..
MC11CT
Ensure injector (behind scanner) is secure and lead vests are laid on scanner table and secured…..
MC11CT
Patient bed (Gurney) to be located behind scanner, brakes applied for transport…..
MC11CT
Ensure the screen is located in the centre of the unit, behind the scanner, and the arm is located in the bracket and secured…..
MC11CT
This trailer has clamps to lock the floor upright whilst in transit, they should be in place when traveling and removed on setup. These…..
C4 IMPERIAL
This CT has an injector stand that locks into the floor and to the injector, this should be in place when traveling and removed…..
C4 IMPERIAL
This CT bed has an adjustable bed bracket with a top brace and end stop, the headrest may have to be removed to fit…..
C4 IMPERIAL
This CT has tilt locks at the back, they should be in place for transit and removed when set up. These are stowed in…..
C4 IMPERIAL
This CT has a Lock pin that goes in the side of the CT for transit and should be removed when setting up. Do…..
C4 IMPERIAL
This trailer has tilt guards on the scanner, these should be in place when moving and removed on setup. Guards are kept in the…..
This trailer requires that the air-con be turned on when setting up. The controls are in the cupboard above the desk in the control…..
When packing down inflate the transport airbag (set to auto) and check to see that the transport light is on at the front of…..
MC05
MC06
RM15
use the steel brackets and slide bolts to secure the two floor panels in the upright position. When not in use the brackets and…..
MC05
MC06
There are 2 brackets for the bed, these are secured using 8 butterfly bolts, the brackets are stowed in the belly locker when not…..
MC05
MC06
